Advance Security R54 Car Alarm Receiver User Manual CA Elite 6 series Install rev A 4 13 09

Advance Security Inc Car Alarm Receiver CA Elite 6 series Install rev A 4 13 09

Contents

user manual 2

12010 Audiovox Electronics Corporation. All rights reserved.PROFESSIONALSERIESIMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual isapplicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/ORSAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information. Remote Start and KeylessEntry SystemCA6150RXOwner’s Guide
2 2010 Audiovox Electronics Corporation. All rights reserved.Table of ContentsUsing Your Remote Control ............................................................... 3Using the Keyless Entry ................................................................... 3Two Stage Door Unlock (optional) ................................................... 3Activating Trunk Release (optional) ................................................ 3Using the Progressive Car Finder Feature...................................... 3Using the Personal Protection Alarm ............................................... 3Programmed Transmitter Notification .............................................. 4Valet Mode ........................................................................................ 4Eliminating Lock / Unlock Notification Chirps ................................... 4Using Your Remote Vehicle Starter ................................................. 4Remote Starting Your Vehicle .......................................................... 4Remote Start Shutdown ................................................................... 4Entering Your Vehicle while it is Running via Remote Start ........... 5Preheating or Precooling the Vehicle’s Interior ............................... 5User Programmable Run Time / Run Time Extension ...................... 5Using the “Quick-Stop” Feature ....................................................... 5Operating the 2 / 3 Hour Start Up Timer Mode ................................ 6Operating the Daily Start Timer ........................................................ 6Remote Start Safety Features ......................................................... 7Transmitter Button Functions ........................................................... 7Replacing Remote Control Batteries ............................................... 8Warranty Information........................................................................... 9
32010 Audiovox Electronics Corporation. All rights reserved.Using Your Remote Control Using the Keyless EntryThe button is used to lock the vehicle's doors, the button is used to unlock thevehicle's doors. To lock or unlock the doors simply press and release the desiredfunction button one time. For your convenience, the parking lights will flash oncewhen the doors are unlocked and twice when the door are locked.NOTE: The system is defaulted with Silent Choice enabled, which requires asecond press of the or button to activate an audible locking/unlockingresponse from the vehicle. If your system is set up for 2 step unlock, a third pressof unlock will activate the audible response. Using the Progressive Car Finder FeaturePress the button to locate your vehicle. The system will sound 5 times at lowvolume, increasing in volume each time the button is pressed. Using the Personal Protection Alarm (Panic)Press and hold the button for 3 seconds to activate the personal protectionalarm. During panic mode, the normal function of the transmitter buttons will besuspended. The transmitter’s and buttons can be used to lock and unlock thedoor (if the option is installed). To stop the alarm, press and hold the button onthe transmitter again for 3 seconds. The system will automatically stop after 30seconds. Activating AUX 1 (Optional)If this feature is enabled on your system, pressing the and buttonssimultaneously will activate an optional feature. This feature can be programmedfor a wide range of functions like power window or sunroof automation, pleaseconsult your installing dealer to determine the functionality of your system. Activating the Trunk Release Feature (Optional)The button is used to open the trunk of the vehicle. To open the vehicle's trunkpress and hold the button for 3 seconds. Two Stage Door Unlock (Optional)If this feature is enabled on your system, pressing the button one time willunlock only the driver’s door. Press again within three seconds to unlock theremaining doors.
4 2010 Audiovox Electronics Corporation. All rights reserved. Valet ModeValet Mode is used to disable the system from remote starting. Toenter or exit valet mode simply follow the 4 steps outlined below:1. Turn the vehicle’s ignition ON.2. Push and hold the programming/valet button.3. The LED will turn on solid when valet mode is active4. Release the programming/valet button. Programmed Transmitter NotificationAs a security precaution each time the vehicle’s ignition is turn on the status LEDlight with flash the number of transmitters programmed into the system. This helpsto identify unauthorized transmitters from accessing your vehicle. If you believe anunauthorized transmitter has been programmed to your system, contact yourinstalling dealer for assistance. Eliminating Lock / Unlock Notification ChirpsSystem lock and unlock notification chirps can be toggled ON or OFF withoutentering the programming feature banks.1. Turn the ignition ON then OFF.2. Press and release the valet/programming button 3 times. The systemwill respond with 1 chirp for ON or 2 chirps for OFF.Using Your Remote Control Remote Starting Your VehicleTo activate the remote vehicle start function, press and release the button 2 timeswithin 2 seconds. The system will sound, the parking lights will flash 1 time and thesystem will check the vehicle to ensure it is safe to start. If all safety parameters arecorrect, the vehicle will start within 5 seconds. The vehicle’s parking lights will turnon (or flash depending on system settings) as a visual indication that the vehicle hasstarted and is running.If your vehicle stalls or does not start, the system will pause 5 seconds, then try 2more times to start the vehicle (a total of 3 attempts). The system will pause 5seconds between each start attempt. If the vehicle does not start after the 3rdattempt, the system will abort the remote vehicle start process. Remote Start ShutdownPress and hold the button for 3 seconds to turn the vehicle off.
52010 Audiovox Electronics Corporation. All rights reserved. Preheating or Precooling the Vehicle’s interiorBefore exiting the vehicle, set the temperature controls to the desired setting andoperation. After the system starts the vehicle, the heater or air conditioner willactivate and heat or cool the vehicle’s interior to your setting. Entering the Vehicle while it is Running via Remote Vehicle Start1. Unlock the vehicle’s doors.2. Enter the vehicle. DO NOT PRESS THE BRAKE PEDAL!3. Insert the key into the ignition switch and turn to the ON or RUNposition.4. Press the brake pedal. The remote vehicle starter will disengage andthe vehicle will operate normally. Using the “Quick-stop” FeatureIf you want to make a short stop and keep your vehicle running (to keep theinterior warm or cool), the quick-stop feature allows you to do this while keepingyour vehicle secure and your keys with you.To engage quick stop:1. Stop the vehicle and place the transmission in PARK.2. With your foot off the brake pedal, press and release the button 2times within 2 seconds. The LED will flash 3 times to confirm quickstop is entered.3. Remove the keys from the ignition and exit the vehicle. Press the button to lock the vehicle’s doors if desired.Note: Do not leave children or animals unattended in the vehicle when using thequick-stop feature. User Programmable Run Time / Run Time ExtensionThe system has the ability to allow the user to extend the time the vehicle will berunning under control of the remote start. This will only extend the run time back tothe current run time setting during the current remote start cycle. If your system isset to run 15 minutes and the time remaining is 4 minutes, extending the run time willreset the countdown timer to 15 minutes and your vehicle will continue to run foranother 15 minutes. Follow the steps below to extend the vehicle’s run time.1. The remote start must already be active.2. Press and release the button 4 times.3. The system will chirp to confirm that the run time has been reset.
6 2010 Audiovox Electronics Corporation. All rights reserved. Operating the Daily Start TimerThe system has the ability to start your vehicle based on a 24-hour countdowntimer. This feature requires a two-part activation sequence. From the remote,pressing both the & buttons together will activate the 24 hour countdowntimer (the vehicle will start 24 hours from this time). Next, When you are finishedoperating the vehicle for the day, perform the following steps to complete theprocess.1. Turn the ignition ON/OFF (vehicle must be disarmed).2. Within 10 seconds, while pressing the brake, press and release the button twice.3. The vehicle will emit 2 chirps.To begin the 2 / 3 hour start up timer mode:1. Turn the vehicle’s ignition ON then OFF.2. Press and hold the valet button.3. Press the button 4 times, the system will chirp 2 times and flash theparking lights 4 times.4. Release the valet button.To exit the 2 / 3 hour start up timer mode:1. Turn the vehicle’s Ignition ON.OR1. Activate the remote vehicle start feature using the remote control. Operating the 2 / 3 Hour Start Up Timer ModeThe system has the ability to start the vehicle every 2 or 3 hours for a 48 hourperiod. This feature is especially useful in cold climates where the only means tokeep the engine and engine fluids warm is to periodically start the engine. Thedefault setting is 3 hour, selection between 2 or 3 hour is made in optionprogramming.WARNING!Be certain that the vehicle is outdoors before using this or any remote startingdevice. A running engine produces dangerous carbon monoxide fumes which canbe harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicleif it is garaged.
72010 Audiovox Electronics Corporation. All rights reserved. Remote Start Safety FeaturesFor safety and security reasons, the system will shutdown or prevent the remotevehicle starter from activating if any of the following occur:1. The vehicle hood is open.2. The brake pedal is pressed prior to turning the ignition key to the ONposition.3. The engine is over-reved (tach checking only).4. Valet mode is active.Transmitter Button Functions1 Way TransmitterLock Unlock Car Find / PanicStart Operation MethodLock X Press and ReleaseUnlock X Press and ReleaseTrunk X Push and Hold (3 Sec) AUX 1 X X Push and Hold (3 Sec) Car Finder X Press and ReleasePanic X Push and Hold (3 Sec) Remote Start XPress and Release (1 or 2 times depending on selectable option) Remote Start Shut DownXPush and Hold (3 Sec) Run Time ExtentionXPress and Release 4 times.2 / 3 Hour Start XIgnition ON/OFF, Press and Hold Valet Button, Press Start 4 timesDaily Start Timer X X Press Lock + Start
8 2010 Audiovox Electronics Corporation. All rights reserved.Replacing Remote Control Batteries1-Way Remote Control: The batteries (model CR2016) inside each remote control should last approximately1 year under normal use. When the batteries become weak you will notice theremote control range (the distance from the vehicle the remote control will work)deteriorate and the small LED on the remote control will dim. To replace the remotecontrol batteries:1. Remove 3 screws and disassemble the halves of the remote control.2. Remove the old batteries, observing the +/- symbols on the batteriesand replace with new CR2016 batteries.3. Reassemble the halves of the remote control and install the 3 screws.4. Test operation of the remote control.
92010 Audiovox Electronics Corporation. All rights reserved.Code Systems, Inc. Limited Lifetime WarrantyCode Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehiclesecurity product (the “Product”), purchased from an authorized CODE dealer, that (except asprovided below) should this Product under normal use and conditions, be proven defective inmaterial or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGI-NALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without chargefor parts directly related to repairs of the defect(s).Switches, indicator lights, and transmitter cases are similarly warranted to the original purchaserfor a period of one (1) year from the date of purchase of the Product.CODE accessories, sold separately, are covered by the applicable warranty accompanying theaccessory.This warranty is non-transferable, non-assignable and is voided when: (1) the Product is removedfrom the vehicle in which it was originally installed; or (2) the vehicle in which the Product wasoriginally installed is transferred to another party.This warranty does not apply to any product damaged by accident, physical or electrical abuse,improper installation, alteration, or use contrary to its intended function, fire, flood, or othernatural acts.In order for the Product to be repaired or replaced under the terms of this warranty, the defectiveProduct must be returned to an authorized CODE dealer and accompanied by a copy of the retailsales receipt. The date of purchase and year, make and model of the vehicle in which the Productwas originally installed must be clearly indicated on the sales receipt.This warranty is exclusive and CODE MAKES NO OTHER WARRANTIES EXPRESSED ORIMPLIED. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MER-CHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO THEDURATION OF THIS WRITTEN WARRANTY. IN NO CASE SHALL CODE BE LIABLE FOR ANYCONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHERWARRANTY, EXPRESS OR IMPLIED, WHATSOEVER.CODE does not warrant that the Product cannot be compromised or circumvented. THE EXTENTOF CODE’S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACE-MENT PROVIDED ABOVE AND, IN NO EVENT SHALL CODE’S LIABILITY EXCEED THE PUR-CHASE PRICE PAID BY THE ORIGINAL PURCHASER OF THE PRODUCT WITHOUT INSTAL-LATION LABOR.Some states do not allow the exclusion or limitation of incidental or consequential damages, so theabove limitation may not apply to you. This warranty gives you specific legal rights and you mayalso have other rights which vary from state to state
10 2010 Audiovox Electronics Corporation. All rights reserved.Audiovox Electronics Corporation.Customer Service 1-800-421-3209WWW.CODE-ALARM.COMFCC COMPLIANCEThis device complies with Part 15 of the FCC rules and with RSS-210 ofIndustry Canada. Operation is subject to the following two conditions:1. This device may not cause harmful interference, and2. This device must accept any interference received, including any interferencethat may cause undesired operation.Warning!Changes or modifications not expressly approved by the party responsible forcompliance could void the user’s authority to operate the equipment.

Navigation menu