Leidos LPR902M-ICU-0 AVL GPS User Manual 293476

Science Application International Corporation AVL GPS 293476

Page1 Statement

1. The Cingular Interactive Wireless Data (CIWD) In-Vehicle Control Unit (ICU), Model LCM386-20531200006 and CIWD/Mobil Satellite (MSAT) ICU, Model LCM386-20531200009) are ruggedized, in-vehicle computers developed by Symbol Technologies Inc. for Science Applications International Corporation (SAIC). These ICUs provide terrestrial wireless or Satellite communications, GPS positioning and Remote Alert Capability. The ICU uses an 80386 processor and supports the MS-DOS, Operating System using industry standard protocols. Error! Reference source not found. and 2 show the front and rear panels of both ICUs. The Wireless Matrix MBS (MSAT MODEM) is a data radio unit used to receive and transmit RF signals to and from a Geo-stationary orbital satellite. (CC 19 Only). Safety Precautions Read and understand the entire manual and follow the safety instructions. WARNING: To meet the FCC RF exposure requirement for mobile transmitters as specified in the FCC’s Rules (47 CFR Section 2.1091) and specifically as it applies to BellSouth Fleet Manager Vehicle equipment configuration ensure that the CIWD antenna is at least 7.9 inches (20 cm) and the Satellite Modem 36 inches (91.44 cm) away from the vehicle operator or nearby persons when transmitting. 1. Replace fuses with same type and rating for protection against fire and damage. 2. The ICU and MSAT Modem are Radio Frequency (RF) generating devices. Do not operate the unit when anyone is in the vicinity noted in the Warning above. This could result in personal injury. 3. Use discretion when determining the Wireless Matrix MBS installation point. After installation, ensure that all systems are functioning properly. 4. Use caution when installing screws or drilling through the body of the vehicle to avoid puncturing critical areas. 5. Install included grommets and weather sealant to protect cable integrity and weatherproofing the area of penetration. 6. Follow the instruction enumerated in the Installation Section of this guide to ensure proper hardware installation. 7. Ensure that the Antenna(s) and Satellite Modem are installed in an area with sufficient overhead clearance where it will NOT collide with any other surfaces and in a location that will NOT affect the RF transmission. 8. Pay close attention to the electrical power installation requirements described in this guide. Failure to comply with the described section could result in serious damage to the electrical system of the vehicle. 2. About This Guide This manual describes how to: Prepare and install the ICU and associated hardware Program the Remote Alert Transmitter (RAT) Key Fobs
Perform troubleshooting and maintenance activities

Navigation menu