ST Engineering Telematics Wireless RSC-900 User Manual revised manual

Telematics Wireless Ltd. revised manual

Contents

revised manual

DRAFTDRAFTRSC-900Road Side CommunicatorUser ManualNOTE:This equipment has been tested and found to comply  with the limitsfor a Class A digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection againstharmful interference when the equipment is operated in acommercial environment. This equipment generates, uses, and canradiate radio frequency energy and, if not installed and used inaccordance with the instruction manual, may cause harmfulinterference to radio communications. Operation of this equipmentin a residential area is likely to cause harmful interference in whichcase the user will be required to correct the interference at his ownexpense.
DRAFTDRAFTInstallation & Operation instructionsThe RSC has to be installed on a horizontal pipe above the center of a road lane.              The pipe has to be 1.5” up to 2” in diameter, and its length has to be sufficient to locate the RSCover the center of the lane. (The width of a standard lane is about 3.6m). For longer pipes and forareas with extreme winds it is important to add additional supports (still cables, etc.) to preventbending of the pipe.Installation of  RSC on the pipeThe unit has two U stretchers that are connecting the main plate to the horizontal pipe.U stretchers
DRAFTDRAFTRSC cable connection1. Connect  the RSC Cable to RSC connectorThe RSC antenna and antenna cable are untegral part of the RSC-900.The use of any antenna other than the one being an integral part of the RSC-900 is expresslyforbidden in accordance with FCC rules CFR47 part 15.204.Power and communication connections• Connect  the main power (24 V) to the  RSC cable  to  pins No 23/24 (+)  and  pinsNo.21/22 (-)RSC ConnectorAntenna Cable RSC cable
DRAFTDRAFT• Connect  the Communication line to the  RSC cable  to  pins No: 11 (TXD), 10 (RXD),and  21/22 (GND)First operation testCall  operating center for communication test and unit remote initialization.We will be happy to assist you at customer support centerTel:Fax:Operating copany  Name Logo and adressHere we will add additional instructions according to the operating company requests

Navigation menu